Prusa3D Forum

Benachrichtigungen

Alles löschen

John McCauley

Gruppe: Registriert

Beigetreten: 2022/08/17

Eminent Member

	Thanks. I actually turned off the fan. Still did not get hot... Im Forum PrusaSlicer	Vor 1 year
	That is my fall back. Right now it is not an issue. Point be... Im Forum General discussion, announcements and releases	Vor 1 year
	Latest firmware 6.0.4 does seem to work well with high temp ... Im Forum General discussion, announcements and releases	Vor 1 year
	Still need to contact Prusa. Looks like the Prusa XL just is... Im Forum How do I print this? (Printing help)	Vor 1 year
	Chamber temperature not followed on XL with enclosure Im Forum PrusaSlicer	Vor 1 year
	Not sure how I missed it there is a Chamber temperature sett... Im Forum How do I print this? (Printing help)	Vor 1 year
	See my thread on printing ABS-CF. Also need high temperature... Im Forum How do I print this? (Printing help)	Vor 1 year
	I turned off the fan on the printhead. So initially the temp... Im Forum How do I print this? (Printing help)	Vor 1 year
	For small prints there are no issues. The print that I had s... Im Forum How do I print this? (Printing help)	Vor 1 year
	Printing ABS-CF, needing 50c in the enclosure Im Forum How do I print this? (Printing help)	Vor 1 year
	Increasing the temperature did fix it for the test print but... Im Forum Assembly and first prints troubleshooting	Vor 1 year
	The first layer was sticking correctly. So I increased the t... Im Forum Assembly and first prints troubleshooting	Vor 1 year
	Bumpy surface Im Forum Assembly and first prints troubleshooting	Vor 1 year
	Print issue with object alignment Im Forum Hardware, firmware and software help	Vor 2 years
	I think I have found a way to do it. Always save to file and... Im Forum General discussion, announcements and releases	Vor 2 years
	Thanks, that is needed. I think the solution is to add the f... Im Forum General discussion, announcements and releases	Vor 2 years
	How do I keep the tool assignments, when updating model? Im Forum General discussion, announcements and releases	Vor 2 years
	Chatted with support. Tried again and it worked! Im Forum Assembly and first prints troubleshooting	Vor 2 years
	First print from PRUSA slicer failed Im Forum Assembly and first prints troubleshooting	Vor 2 years
	So far so good Im Forum Assembly and first prints troubleshooting	Vor 2 years

Seite 1 / 2 Nächstes

Forums-Statistiken

595 Foren

68.9 K Themen

481.7 K Beiträge

13 Online

77.5 K Mitglieder

Letzter Beitrag: Horizontal surface patterns / uneven layers Unser neuestes Mitglied: HaydenWizard Neueste Beiträge Ungelesene Beiträge Schlagwörter

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen