Prusa3D Forum

Notifications

Clear all

John McCauley

Groupe: Enregistré

A(ont) rejoint: 2022/08/17

Eminent Member

	Thanks. I actually turned off the fan. Still did not get hot... Dans le forum PrusaSlicer	il y a 3 months
	That is my fall back. Right now it is not an issue. Point be... Dans le forum General discussion, announcements and releases	il y a 4 months
	Latest firmware 6.0.4 does seem to work well with high temp ... Dans le forum General discussion, announcements and releases	il y a 4 months
	Still need to contact Prusa. Looks like the Prusa XL just is... Dans le forum How do I print this? (Printing help)	il y a 6 months
	Chamber temperature not followed on XL with enclosure Dans le forum PrusaSlicer	il y a 6 months
	Not sure how I missed it there is a Chamber temperature sett... Dans le forum How do I print this? (Printing help)	il y a 6 months
	See my thread on printing ABS-CF. Also need high temperature... Dans le forum How do I print this? (Printing help)	il y a 6 months
	I turned off the fan on the printhead. So initially the temp... Dans le forum How do I print this? (Printing help)	il y a 6 months
	For small prints there are no issues. The print that I had s... Dans le forum How do I print this? (Printing help)	il y a 6 months
	Printing ABS-CF, needing 50c in the enclosure Dans le forum How do I print this? (Printing help)	il y a 6 months
	Increasing the temperature did fix it for the test print but... Dans le forum Assembly and first prints troubleshooting	il y a 8 months
	The first layer was sticking correctly. So I increased the t... Dans le forum Assembly and first prints troubleshooting	il y a 8 months
	Bumpy surface Dans le forum Assembly and first prints troubleshooting	il y a 8 months
	Print issue with object alignment Dans le forum Hardware, firmware and software help	il y a 9 months
	I think I have found a way to do it. Always save to file and... Dans le forum General discussion, announcements and releases	il y a 12 months
	Thanks, that is needed. I think the solution is to add the f... Dans le forum General discussion, announcements and releases	il y a 12 months
	How do I keep the tool assignments, when updating model? Dans le forum General discussion, announcements and releases	il y a 12 months
	Chatted with support. Tried again and it worked! Dans le forum Assembly and first prints troubleshooting	il y a 1 year
	First print from PRUSA slicer failed Dans le forum Assembly and first prints troubleshooting	il y a 1 year
	So far so good Dans le forum Assembly and first prints troubleshooting	il y a 1 year

Page 1 / 2 Suivant

Statistiques du forum

565 Forums

63.6 K Sujets

446.3 K Messages

19 En-ligne

69 K Membres

Le dernier des messages: MK4S/MMU3 Print Issues Notre nouveau membre: twh344 Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé