Prusa3D Forum

Notifications

Clear all

John McCauley

Skupina: Registrovaný

Přidal se: 2022/08/17

Eminent Member

	Thanks. I actually turned off the fan. Still did not get hot... In forum PrusaSlicer	před 1 year
	That is my fall back. Right now it is not an issue. Point be... In forum General discussion, announcements and releases	před 1 year
	Latest firmware 6.0.4 does seem to work well with high temp ... In forum General discussion, announcements and releases	před 1 year
	Still need to contact Prusa. Looks like the Prusa XL just is... In forum How do I print this? (Printing help)	před 1 year
	Chamber temperature not followed on XL with enclosure In forum PrusaSlicer	před 1 year
	Not sure how I missed it there is a Chamber temperature sett... In forum How do I print this? (Printing help)	před 1 year
	See my thread on printing ABS-CF. Also need high temperature... In forum How do I print this? (Printing help)	před 1 year
	I turned off the fan on the printhead. So initially the temp... In forum How do I print this? (Printing help)	před 1 year
	For small prints there are no issues. The print that I had s... In forum How do I print this? (Printing help)	před 1 year
	Printing ABS-CF, needing 50c in the enclosure In forum How do I print this? (Printing help)	před 1 year
	Increasing the temperature did fix it for the test print but... In forum Assembly and first prints troubleshooting	před 1 year
	The first layer was sticking correctly. So I increased the t... In forum Assembly and first prints troubleshooting	před 1 year
	Bumpy surface In forum Assembly and first prints troubleshooting	před 1 year
	Print issue with object alignment In forum Hardware, firmware and software help	před 2 years
	I think I have found a way to do it. Always save to file and... In forum General discussion, announcements and releases	před 2 years
	Thanks, that is needed. I think the solution is to add the f... In forum General discussion, announcements and releases	před 2 years
	How do I keep the tool assignments, when updating model? In forum General discussion, announcements and releases	před 2 years
	Chatted with support. Tried again and it worked! In forum Assembly and first prints troubleshooting	před 2 years
	First print from PRUSA slicer failed In forum Assembly and first prints troubleshooting	před 2 years
	So far so good In forum Assembly and first prints troubleshooting	před 2 years

Stránka 1 / 2 Další

Fórum Statistiky

595 Fóra

68.8 K Témata

481.5 K Příspěvky

12 Online

77.4 K Uživatelé

Poslední Příspěvek: Longer cable, what are the connectors? Nový Uživatel: mike Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed