Prusa3D Forum

Benachrichtigungen

Alles löschen

John McCauley

Gruppe: Registriert

Beigetreten: 2022/08/17

Eminent Member

	Thanks. I actually turned off the fan. Still did not get hot... Im Forum PrusaSlicer	Vor 11 months
	That is my fall back. Right now it is not an issue. Point be... Im Forum General discussion, announcements and releases	Vor 1 year
	Latest firmware 6.0.4 does seem to work well with high temp ... Im Forum General discussion, announcements and releases	Vor 1 year
	Still need to contact Prusa. Looks like the Prusa XL just is... Im Forum How do I print this? (Printing help)	Vor 1 year
	Chamber temperature not followed on XL with enclosure Im Forum PrusaSlicer	Vor 1 year
	Not sure how I missed it there is a Chamber temperature sett... Im Forum How do I print this? (Printing help)	Vor 1 year
	See my thread on printing ABS-CF. Also need high temperature... Im Forum How do I print this? (Printing help)	Vor 1 year
	I turned off the fan on the printhead. So initially the temp... Im Forum How do I print this? (Printing help)	Vor 1 year
	For small prints there are no issues. The print that I had s... Im Forum How do I print this? (Printing help)	Vor 1 year
	Printing ABS-CF, needing 50c in the enclosure Im Forum How do I print this? (Printing help)	Vor 1 year
	Increasing the temperature did fix it for the test print but... Im Forum Assembly and first prints troubleshooting	Vor 1 year
	The first layer was sticking correctly. So I increased the t... Im Forum Assembly and first prints troubleshooting	Vor 1 year
	Bumpy surface Im Forum Assembly and first prints troubleshooting	Vor 1 year
	Print issue with object alignment Im Forum Hardware, firmware and software help	Vor 1 year
	I think I have found a way to do it. Always save to file and... Im Forum General discussion, announcements and releases	Vor 2 years
	Thanks, that is needed. I think the solution is to add the f... Im Forum General discussion, announcements and releases	Vor 2 years
	How do I keep the tool assignments, when updating model? Im Forum General discussion, announcements and releases	Vor 2 years
	Chatted with support. Tried again and it worked! Im Forum Assembly and first prints troubleshooting	Vor 2 years
	First print from PRUSA slicer failed Im Forum Assembly and first prints troubleshooting	Vor 2 years
	So far so good Im Forum Assembly and first prints troubleshooting	Vor 2 years

Seite 1 / 2 Nächstes

Forums-Statistiken

585 Foren

67.9 K Themen

475.9 K Beiträge

11 Online

75.5 K Mitglieder

Letzter Beitrag: Help printing with PC Blend without warping Unser neuestes Mitglied: klong Neueste Beiträge Ungelesene Beiträge Schlagwörter

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen