Notifications
Clear all
John McCauley
John McCauley
Group: Registered
Joined: 2022/08/17
Eminent Member
2
Thanks. I actually turned off the fan. Still did not get hot...

In forum PrusaSlicer

11 months ago
That is my fall back. Right now it is not an issue. Point be...

In forum General discussion, announcements and releases

1 year ago
Latest firmware 6.0.4 does seem to work well with high temp ...

In forum General discussion, announcements and releases

1 year ago
Still need to contact Prusa. Looks like the Prusa XL just is...

In forum How do I print this? (Printing help)

1 year ago
Chamber temperature not followed on XL with enclosure

In forum PrusaSlicer

1 year ago
Not sure how I missed it there is a Chamber temperature sett...

In forum How do I print this? (Printing help)

1 year ago
See my thread on printing ABS-CF. Also need high temperature...

In forum How do I print this? (Printing help)

1 year ago
I turned off the fan on the printhead. So initially the temp...

In forum How do I print this? (Printing help)

1 year ago
For small prints there are no issues. The print that I had s...

In forum How do I print this? (Printing help)

1 year ago
Printing ABS-CF, needing 50c in the enclosure

In forum How do I print this? (Printing help)

1 year ago
Increasing the temperature did fix it for the test print but...

In forum Assembly and first prints troubleshooting

1 year ago
The first layer was sticking correctly. So I increased the t...

In forum Assembly and first prints troubleshooting

1 year ago
Bumpy surface

In forum Assembly and first prints troubleshooting

1 year ago
Print issue with object alignment

In forum Hardware, firmware and software help

1 year ago
I think I have found a way to do it. Always save to file and...

In forum General discussion, announcements and releases

2 years ago
Thanks, that is needed. I think the solution is to add the f...

In forum General discussion, announcements and releases

2 years ago
How do I keep the tool assignments, when updating model?

In forum General discussion, announcements and releases

2 years ago
Chatted with support. Tried again and it worked!

In forum Assembly and first prints troubleshooting

2 years ago
First print from PRUSA slicer failed

In forum Assembly and first prints troubleshooting

2 years ago
So far so good

In forum Assembly and first prints troubleshooting

2 years ago
Page 1 / 2
Share: