Polski
Fora
Członkowie
Johan
Aktywność
 
Notifications
Clear all
Johan
Johan
Grupa: Zarejestrowany
Dołączył: 2019/04/30
Eminent Member
2
Profil Aktywność
Sad to hear and will double check all the screws 👍 Continue ...

In forum Assembly and first prints troubleshooting

 2 years temu
Printed with my new XL today and got surprised about all str...

In forum Assembly and first prints troubleshooting

 2 years temu
Worst part was routing the cable in the bottom frame, a few ...

In forum General discussion, announcements and releases

 2 years temu
Hopefully someone from the Prusa team that can reply? It's q...

In forum General discussion, announcements and releases

 3 years temu
Thanks but that is not the dimension I'm looking for. I like...

In forum General discussion, announcements and releases

 3 years temu
I like to know the dimension marked in yellow to be able to ...

In forum General discussion, announcements and releases

 3 years temu
I'm using an old file which I have printed many times before...

In forum How do I print this? (Printing help)

 5 years temu
@wook Sorry to here and what you describe is exactly the sam...

In forum How do I print this? (Printing help)

 5 years temu
@mdaneman No, I got shifted layer on two different files. Th...

In forum How do I print this? (Printing help)

 5 years temu
Printed the same file for the 3rd time (taking 9 hours each ...

In forum How do I print this? (Printing help)

 5 years temu
There is another thread about the same topic:

In forum Others (Archive)

 5 years temu
@mdaneman Printing from SD. I safeguarded and tighten the be...

In forum How do I print this? (Printing help)

 5 years temu
I just got a similar issue, suddenly my X-axis offsets. Runn...

In forum How do I print this? (Printing help)

 5 years temu
@Ryan-f15; did you manage to solve your offset issue? I just...

In forum Others (Archive)

 5 years temu
The filament has not snapped and is stucked. I tried to unlo...

In forum Hardware, firmware and software help

 6 years temu
I just experienced the same issue with the clicking noice an...

In forum Hardware, firmware and software help

 6 years temu
It took some time before my posts was approved by admin so I...

In forum Assembly and first prints troubleshooting

 6 years temu
Tested to print this test model and it worked fine with the ...

In forum Assembly and first prints troubleshooting

 6 years temu
I'm trying to do my first PETG (Prusament) print but can't ...

In forum Assembly and first prints troubleshooting

 6 years temu
Thanks for the prompt response. Embarrassed to say but it wa...

In forum Assembly and first prints troubleshooting

 6 years temu
Strona 1 / 2
Share: