Activité
 
Notifications
Clear all
jim.h
jim.h
Groupe: Enregistré
A(ont) rejoint: 2016/07/19
Eminent Member
2
Ok - I took a look and it looks like most of the parts are a...

Dans le forum General discussion, announcements and releases

il y a 6 years
Could someone print the upgrade parts for me in UK/EU - will...

Dans le forum General discussion, announcements and releases

il y a 6 years
Temperature consistently too low when machine is capable of ...

Dans le forum Hardware, firmware and software help

il y a 7 years
Hi Folks, I'm Susan from rigid.ink. I've been contacted by...

Dans le forum Others (Archive)

il y a 7 years
Any updates? I've been having similar although not identical...

Dans le forum Others (Archive)

il y a 7 years
Some more info: [*] printing in PLA. [*] Same gcode has do...

Dans le forum Others (Archive)

il y a 7 years
Layers not bonding part way through a print

Dans le forum Others (Archive)

il y a 7 years
Now with much thicker wires, and the printer has been runnin...

Dans le forum Others (Archive)

il y a 7 years
Ebay coming through as usual 🙂 4 core rather than 2 lots o...

Dans le forum Others (Archive)

il y a 7 years
Yes, that's right, 0.75² flex that I used is around 6A. I do...

Dans le forum Others (Archive)

il y a 7 years
It looks to me as though that cable is not sufficient rating...

Dans le forum Others (Archive)

il y a 7 years
Similar thread here that I started:

Dans le forum Others (Archive)

il y a 7 years
So I finally found some time to do the soldering (used some ...

Dans le forum Others (Archive)

il y a 7 years
So it sounds like the consensus is to solder the wires from ...

Dans le forum Others (Archive)

il y a 7 years
I've just measured and I get about 1.5 ohms over the termina...

Dans le forum Others (Archive)

il y a 7 years
Ok, thanks. I do have a multi-meter. I will measure when I a...

Dans le forum Others (Archive)

il y a 7 years
Problems with prints resetting, then found burned/melted pow...

Dans le forum Others (Archive)

il y a 7 years
Just to update (I'm the OP) Mine was totally wedged in from...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
That was correct! I heated it with a hot air gun and the gru...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
I've found the grubscrew but it wouldn't turn with even quit...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
Page 1 / 2
Partager :