Prusa3D Forum

Notifications

Clear all

jim.h

Skupina: Registrovaný

Přidal se: 2016/07/19

Eminent Member

	Ok - I took a look and it looks like most of the parts are a... In forum General discussion, announcements and releases	před 6 years
	Could someone print the upgrade parts for me in UK/EU - will... In forum General discussion, announcements and releases	před 6 years
	Temperature consistently too low when machine is capable of ... In forum Hardware, firmware and software help	před 7 years
	Hi Folks, I'm Susan from rigid.ink. I've been contacted by... In forum Others (Archive)	před 7 years
	Any updates? I've been having similar although not identical... In forum Others (Archive)	před 7 years
	Some more info: [] printing in PLA. [] Same gcode has do... In forum Others (Archive)	před 7 years
	Layers not bonding part way through a print In forum Others (Archive)	před 7 years
	Now with much thicker wires, and the printer has been runnin... In forum Others (Archive)	před 7 years
	Ebay coming through as usual 🙂 4 core rather than 2 lots o... In forum Others (Archive)	před 7 years
	Yes, that's right, 0.75² flex that I used is around 6A. I do... In forum Others (Archive)	před 7 years
	It looks to me as though that cable is not sufficient rating... In forum Others (Archive)	před 7 years
	Similar thread here that I started: In forum Others (Archive)	před 7 years
	So I finally found some time to do the soldering (used some ... In forum Others (Archive)	před 7 years
	So it sounds like the consensus is to solder the wires from ... In forum Others (Archive)	před 7 years
	I've just measured and I get about 1.5 ohms over the termina... In forum Others (Archive)	před 7 years
	Ok, thanks. I do have a multi-meter. I will measure when I a... In forum Others (Archive)	před 7 years
	Problems with prints resetting, then found burned/melted pow... In forum Others (Archive)	před 7 years
	Just to update (I'm the OP) Mine was totally wedged in from... In forum Prusa i3 kit (Archive)	před 8 years
	That was correct! I heated it with a hot air gun and the gru... In forum Prusa i3 kit (Archive)	před 8 years
	I've found the grubscrew but it wouldn't turn with even quit... In forum Prusa i3 kit (Archive)	před 8 years

Stránka 1 / 2 Další

Fórum Statistiky

559 Fóra

63.1 K Témata

443.7 K Příspěvky

22 Online

68 K Uživatelé

Poslední Příspěvek: 1.vrstva: rozdíl v kvalitě s poslední vrstvou Nový Uživatel: etiennep Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed