Prusa3D Forum

Benachrichtigungen

Alles löschen

jim.h

Gruppe: Registriert

Beigetreten: 2016/07/19

Eminent Member

	Ok - I took a look and it looks like most of the parts are a... Im Forum General discussion, announcements and releases	Vor 6 years
	Could someone print the upgrade parts for me in UK/EU - will... Im Forum General discussion, announcements and releases	Vor 6 years
	Temperature consistently too low when machine is capable of ... Im Forum Hardware, firmware and software help	Vor 7 years
	Hi Folks, I'm Susan from rigid.ink. I've been contacted by... Im Forum Others (Archive)	Vor 7 years
	Any updates? I've been having similar although not identical... Im Forum Others (Archive)	Vor 7 years
	Some more info: [] printing in PLA. [] Same gcode has do... Im Forum Others (Archive)	Vor 7 years
	Layers not bonding part way through a print Im Forum Others (Archive)	Vor 7 years
	Now with much thicker wires, and the printer has been runnin... Im Forum Others (Archive)	Vor 7 years
	Ebay coming through as usual 🙂 4 core rather than 2 lots o... Im Forum Others (Archive)	Vor 7 years
	Yes, that's right, 0.75² flex that I used is around 6A. I do... Im Forum Others (Archive)	Vor 7 years
	It looks to me as though that cable is not sufficient rating... Im Forum Others (Archive)	Vor 7 years
	Similar thread here that I started: Im Forum Others (Archive)	Vor 7 years
	So I finally found some time to do the soldering (used some ... Im Forum Others (Archive)	Vor 7 years
	So it sounds like the consensus is to solder the wires from ... Im Forum Others (Archive)	Vor 7 years
	I've just measured and I get about 1.5 ohms over the termina... Im Forum Others (Archive)	Vor 7 years
	Ok, thanks. I do have a multi-meter. I will measure when I a... Im Forum Others (Archive)	Vor 7 years
	Problems with prints resetting, then found burned/melted pow... Im Forum Others (Archive)	Vor 7 years
	Just to update (I'm the OP) Mine was totally wedged in from... Im Forum Prusa i3 kit (Archive)	Vor 7 years
	That was correct! I heated it with a hot air gun and the gru... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	I've found the grubscrew but it wouldn't turn with even quit... Im Forum Prusa i3 kit (Archive)	Vor 8 years

Seite 1 / 2 Nächstes

Forums-Statistiken

559 Foren

62.8 K Themen

442.4 K Beiträge

21 Online

67.4 K Mitglieder

Letzter Beitrag: Multiple issues - ready to move back to OctoPrint.... Unser neuestes Mitglied: pinklemonade Neueste Beiträge Ungelesene Beiträge Schlagwörter

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen