Prusa3D Forum

Notifications

Clear all

jim.h

Group: Registered

Joined: 2016/07/19

Eminent Member

	Ok - I took a look and it looks like most of the parts are a... In forum General discussion, announcements and releases	6 years ago
	Could someone print the upgrade parts for me in UK/EU - will... In forum General discussion, announcements and releases	6 years ago
	Temperature consistently too low when machine is capable of ... In forum Hardware, firmware and software help	7 years ago
	Hi Folks, I'm Susan from rigid.ink. I've been contacted by... In forum Others (Archive)	7 years ago
	Any updates? I've been having similar although not identical... In forum Others (Archive)	7 years ago
	Some more info: [] printing in PLA. [] Same gcode has do... In forum Others (Archive)	7 years ago
	Layers not bonding part way through a print In forum Others (Archive)	7 years ago
	Now with much thicker wires, and the printer has been runnin... In forum Others (Archive)	7 years ago
	Ebay coming through as usual 🙂 4 core rather than 2 lots o... In forum Others (Archive)	7 years ago
	Yes, that's right, 0.75² flex that I used is around 6A. I do... In forum Others (Archive)	7 years ago
	It looks to me as though that cable is not sufficient rating... In forum Others (Archive)	7 years ago
	Similar thread here that I started: In forum Others (Archive)	7 years ago
	So I finally found some time to do the soldering (used some ... In forum Others (Archive)	7 years ago
	So it sounds like the consensus is to solder the wires from ... In forum Others (Archive)	7 years ago
	I've just measured and I get about 1.5 ohms over the termina... In forum Others (Archive)	7 years ago
	Ok, thanks. I do have a multi-meter. I will measure when I a... In forum Others (Archive)	7 years ago
	Problems with prints resetting, then found burned/melted pow... In forum Others (Archive)	7 years ago
	Just to update (I'm the OP) Mine was totally wedged in from... In forum Prusa i3 kit (Archive)	7 years ago
	That was correct! I heated it with a hot air gun and the gru... In forum Prusa i3 kit (Archive)	8 years ago
	I've found the grubscrew but it wouldn't turn with even quit... In forum Prusa i3 kit (Archive)	8 years ago

Page 1 / 2 Next

Forum Statistics

559 Forums

62.8 K Topics

442.4 K Posts

19 Online

67.4 K Members

Latest Post: Multiple issues - ready to move back to OctoPrint.... Our newest member: pinklemonade Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed