Aktywność
 
Notifications
Clear all
jim.h
jim.h
Grupa: Zarejestrowany
Dołączył: 2016/07/19
Eminent Member
2
Ok - I took a look and it looks like most of the parts are a...

In forum General discussion, announcements and releases

6 years temu
Could someone print the upgrade parts for me in UK/EU - will...

In forum General discussion, announcements and releases

6 years temu
Temperature consistently too low when machine is capable of ...

In forum Hardware, firmware and software help

7 years temu
Hi Folks, I'm Susan from rigid.ink. I've been contacted by...

In forum Others (Archive)

7 years temu
Any updates? I've been having similar although not identical...

In forum Others (Archive)

7 years temu
Some more info: [*] printing in PLA. [*] Same gcode has do...

In forum Others (Archive)

7 years temu
Layers not bonding part way through a print

In forum Others (Archive)

7 years temu
Now with much thicker wires, and the printer has been runnin...

In forum Others (Archive)

7 years temu
Ebay coming through as usual 🙂 4 core rather than 2 lots o...

In forum Others (Archive)

7 years temu
Yes, that's right, 0.75² flex that I used is around 6A. I do...

In forum Others (Archive)

7 years temu
It looks to me as though that cable is not sufficient rating...

In forum Others (Archive)

7 years temu
Similar thread here that I started:

In forum Others (Archive)

7 years temu
So I finally found some time to do the soldering (used some ...

In forum Others (Archive)

7 years temu
So it sounds like the consensus is to solder the wires from ...

In forum Others (Archive)

7 years temu
I've just measured and I get about 1.5 ohms over the termina...

In forum Others (Archive)

7 years temu
Ok, thanks. I do have a multi-meter. I will measure when I a...

In forum Others (Archive)

7 years temu
Problems with prints resetting, then found burned/melted pow...

In forum Others (Archive)

7 years temu
Just to update (I'm the OP) Mine was totally wedged in from...

In forum Prusa i3 kit (Archive)

8 years temu
That was correct! I heated it with a hot air gun and the gru...

In forum Prusa i3 kit (Archive)

8 years temu
I've found the grubscrew but it wouldn't turn with even quit...

In forum Prusa i3 kit (Archive)

8 years temu
Strona 1 / 2
Share: