ironfan72 – Activité – Prusa3D Forum

Notifications

Clear all

ironfan72

Groupe: Enregistré

A(ont) rejoint: 2023/04/02

Trusted Member

	Just turned my Mk3S on for the first time since getting the ... Dans le forum General discussion, announcements and releases	il y a 2 years
	My smooth PEI sheet did get dented in the z homing position ... Dans le forum General discussion, announcements and releases	il y a 2 years
	I'll add my vote to having the time until a color change dis... Dans le forum Hardware, firmware and software help	il y a 2 years
	I'd definitely prefer that the screen displayed during print... Dans le forum General discussion, announcements and releases	il y a 2 years
	The problem with putting the purge line in the Mk3 position ... Dans le forum General discussion, announcements and releases	il y a 2 years
	I've been getting that message about 50-60% of the time when... Dans le forum Hardware, firmware and software help	il y a 2 years
	If you don't already have a Mk3+ then I would definitely rec... Dans le forum General discussion, announcements and releases	il y a 2 years
	I did the same as Walter, no need to remove the old firmware... Dans le forum General discussion, announcements and releases	il y a 2 years
	I've just completed my second print with the new 4.6.1 firmw... Dans le forum Hardware, firmware and software help	il y a 2 years

Page 4 / 4 Précédent

Statistiques du forum

559 Forums

62.9 K Sujets

443.1 K Messages

20 En-ligne

67.7 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé