Čeština
Fóra
Uživatelé
ironfan72
Aktivita
 
Notifications
Clear all
ironfan72
ironfan72
Skupina: Registrovaný
Přidal se: 2023/04/02
Trusted Member
3
Profile Aktivita
I had it once after the Z homing failed, gouge was in the pu...

In forum Hardware, firmware and software help

 před 2 years
I've had my screen go blank at various times, including duri...

In forum Assembly and first prints troubleshooting

 před 2 years
I've been in touch with them for a few other things like the...

In forum General discussion, announcements and releases

 před 2 years
Just turned my Mk3S on for the first time since getting the ...

In forum General discussion, announcements and releases

 před 2 years
My smooth PEI sheet did get dented in the z homing position ...

In forum General discussion, announcements and releases

 před 2 years
I'll add my vote to having the time until a color change dis...

In forum Hardware, firmware and software help

 před 2 years
I'd definitely prefer that the screen displayed during print...

In forum General discussion, announcements and releases

 před 2 years
The problem with putting the purge line in the Mk3 position ...

In forum General discussion, announcements and releases

 před 2 years
I've been getting that message about 50-60% of the time when...

In forum Hardware, firmware and software help

 před 2 years
If you don't already have a Mk3+ then I would definitely rec...

In forum General discussion, announcements and releases

 před 2 years
I did the same as Walter, no need to remove the old firmware...

In forum General discussion, announcements and releases

 před 2 years
I've just completed my second print with the new 4.6.1 firmw...

In forum Hardware, firmware and software help

 před 2 years
Stránka 4 / 4
Share: