Polski
Fora
Członkowie
ironfan72
Aktywność
 
Notifications
Clear all
ironfan72
ironfan72
Grupa: Zarejestrowany
Dołączył: 2023/04/02
Trusted Member
3
Profil Aktywność
I had it once after the Z homing failed, gouge was in the pu...

In forum Hardware, firmware and software help

 2 years temu
I've had my screen go blank at various times, including duri...

In forum Assembly and first prints troubleshooting

 2 years temu
I've been in touch with them for a few other things like the...

In forum General discussion, announcements and releases

 2 years temu
Just turned my Mk3S on for the first time since getting the ...

In forum General discussion, announcements and releases

 2 years temu
My smooth PEI sheet did get dented in the z homing position ...

In forum General discussion, announcements and releases

 2 years temu
I'll add my vote to having the time until a color change dis...

In forum Hardware, firmware and software help

 2 years temu
I'd definitely prefer that the screen displayed during print...

In forum General discussion, announcements and releases

 2 years temu
The problem with putting the purge line in the Mk3 position ...

In forum General discussion, announcements and releases

 2 years temu
I've been getting that message about 50-60% of the time when...

In forum Hardware, firmware and software help

 2 years temu
If you don't already have a Mk3+ then I would definitely rec...

In forum General discussion, announcements and releases

 2 years temu
I did the same as Walter, no need to remove the old firmware...

In forum General discussion, announcements and releases

 2 years temu
I've just completed my second print with the new 4.6.1 firmw...

In forum Hardware, firmware and software help

 2 years temu
Strona 4 / 4
Share: