Notifications
Clear all
GroovyZ1K
GroovyZ1K
Skupina: Registrovaný
Přidal se: 2019/03/13
Eminent Member
2
I let Slic3r update but now when I hook up my PC to my MK3S ...

In forum General discussion, announcements and releases

před 6 years
I'm curious if the silver PLA filament is Prusament Silver o...

In forum How do I print this? (Printing help)

před 6 years
Quick update, after many attempts to dial in my Z offset usi...

In forum How do I print this? (Printing help)

před 6 years
Here is where we are at now. Bed adhesion is better than ev...

In forum How do I print this? (Printing help)

před 6 years
Forgot to mention, after the cold pull the nozzle looked new...

In forum How do I print this? (Printing help)

před 6 years
An update! Once I got home and was feeling very mellow, I w...

In forum How do I print this? (Printing help)

před 6 years
Thinking I probably should have posted this in Hardware afte...

In forum How do I print this? (Printing help)

před 6 years
Been here. Went crazy. Found the following fixes: 1. The pi...

In forum Hardware, firmware and software help

před 6 years
So, interestingly I flashed to 3.7.0 Sunday morning and had ...

In forum How do I print this? (Printing help)

před 6 years
If you just lifted the PTFE up and out the dust may still tr...

In forum How do I print this? (Printing help)

před 6 years
One other possible source for under-extrusion is debris in t...

In forum How do I print this? (Printing help)

před 6 years
those sides show up allot better in that picture. what happ...

In forum How do I print this? (Printing help)

před 6 years
Just ran another NASA log in Prusa PLA after reverting the f...

In forum How do I print this? (Printing help)

před 6 years
hope it helps. trouble shooting a mk3 single is fun...compar...

In forum How do I print this? (Printing help)

před 6 years
maybe turning the temp up might help When it was back to w...

In forum How do I print this? (Printing help)

před 6 years
as long as the nozzle has that small gap with the heater blo...

In forum How do I print this? (Printing help)

před 6 years
Not sure if it helps, but attached are the settings for Slic...

In forum How do I print this? (Printing help)

před 6 years
This was the print before the trio of dolphins, and it looke...

In forum How do I print this? (Printing help)

před 6 years
I had the same thought on the nozzle gap. I took a look at ...

In forum How do I print this? (Printing help)

před 6 years
maybe the filament is building backpressure. did you calibra...

In forum How do I print this? (Printing help)

před 6 years
Stránka 1 / 2
Share: