Notifications
Clear all
flounder
flounder
Group: Registered
Joined: 2018/05/08
Eminent Member
2
With another hour of flailing about, I got the 3D-print tab ...

In forum PrusaSlicer

1 month ago
According to the expanded information, the “Location” is “3D...

In forum PrusaSlicer

1 month ago
Bad translation/slicing

In forum General discussion, announcements and releases

1 month ago
I have never used Blender before. It was the only program t...

In forum PrusaSlicer

1 month ago
Imports fail, message useless

In forum PrusaSlicer

1 month ago
Thanks. I just got to bed, will check it on Friday if I hav...

In forum Assembly and first prints troubleshooting

2 months ago
Unremovable supports

In forum Assembly and first prints troubleshooting

2 months ago
First layer calibration 0.6mm nozzle

In forum User mods, enclosures, nozzles, ...

8 months ago
Positioning print correctly

In forum How do I print this? (Printing help)

9 months ago
No extrusion

In forum General discussion, announcements and releases

10 months ago
No extrusion

In forum Hardware, firmware and software help

10 months ago
Here's the project file I used...  Nine-Clips-with-Br...

In forum How do I print this? (Printing help)

2 years ago
I went to and found a pointer to Using this, I was able to...

In forum How do I print this? (Printing help)

2 years ago
I can do that, but I seem to have found a solution. Unfortu...

In forum How do I print this? (Printing help)

2 years ago
No, it fails completely. That's what I normally have select...

In forum How do I print this? (Printing help)

2 years ago
Brim Control

In forum How do I print this? (Printing help)

2 years ago
Mouse-watch error in PrusaSlicer

In forum PrusaSlicer

2 years ago
Multimonitor bug in PrusaSlicer

In forum PrusaSlicer

2 years ago
I missed that fourth fuse. However, I have now checked it a...

In forum General discussion, announcements and releases

2 years ago
Do I really have to get a cheap multimeter? I’d rather use ...

In forum General discussion, announcements and releases

2 years ago
Page 1 / 3
Share: