Erik – Aktivita – Prusa3D Forum

Notifications

Clear all

Erik

Skupina: Registrovaný

Přidal se: 2018/03/22

Eminent Member

	Okay, I tried again, printing off the SD card to eliminate O... In forum Hardware, firmware and software help	před 5 years
	I've had the same experience with PETG (very high adhesion).... In forum General discussion, announcements and releases	před 5 years
	Can't upload two pics in a single post, so here's the second... In forum Hardware, firmware and software help	před 5 years
	Okay, I did a PID calibration at 260, and tried to print the... In forum Hardware, firmware and software help	před 5 years
	No, I have not. I haven't done a PID cal since months ago. I... In forum Hardware, firmware and software help	před 5 years
	Thermal runaway, printer keeps "printing" In forum Hardware, firmware and software help	před 5 years
	You have to login Thanks, that was the trick! I was going ... In forum General discussion, announcements and releases	před 6 years
	Advice for 0.6 nozzle settings for MMU2S multi printing? In forum General discussion, announcements and releases	před 6 years
	Can you provide link to the page, please? For the life of me... In forum General discussion, announcements and releases	před 6 years
	Going to try this, as I just had a 2 day print killed by the... In forum Others (Archive)	před 6 years

Stránka 2 / 2 Předchozí

Fórum Statistiky

579 Fóra

65.6 K Témata

459.4 K Příspěvky

24 Online

73 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed