Erik – Aktywność – Prusa3D Forum

Notifications

Clear all

Erik

Grupa: Zarejestrowany

Dołączył: 2018/03/22

Eminent Member

	Okay, I tried again, printing off the SD card to eliminate O... In forum Hardware, firmware and software help	5 years temu
	I've had the same experience with PETG (very high adhesion).... In forum General discussion, announcements and releases	5 years temu
	Can't upload two pics in a single post, so here's the second... In forum Hardware, firmware and software help	5 years temu
	Okay, I did a PID calibration at 260, and tried to print the... In forum Hardware, firmware and software help	5 years temu
	No, I have not. I haven't done a PID cal since months ago. I... In forum Hardware, firmware and software help	5 years temu
	Thermal runaway, printer keeps "printing" In forum Hardware, firmware and software help	5 years temu
	You have to login Thanks, that was the trick! I was going ... In forum General discussion, announcements and releases	6 years temu
	Advice for 0.6 nozzle settings for MMU2S multi printing? In forum General discussion, announcements and releases	6 years temu
	Can you provide link to the page, please? For the life of me... In forum General discussion, announcements and releases	6 years temu
	Going to try this, as I just had a 2 day print killed by the... In forum Others (Archive)	6 years temu

Strona 2 / 2 Wstecz

Statystyki Forum

565 Fora

64.5 K Tematy

451.8 K Posty

23 Online

71.1 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte