Français
Forums
Membres
Erik
Activité
 
Notifications
Clear all
Erik
Erik
Groupe: Enregistré
A(ont) rejoint: 2018/03/22
Eminent Member
2
Profil Activité
Yes, you are right; thank you for the correction. I'll edit ...

Dans le forum General discussion, announcements and releases

 il y a 5 years
There are a multitude of different contaminants that can fin...

Dans le forum General discussion, announcements and releases

 il y a 5 years
Okay, I tried again, printing off the SD card to eliminate O...

Dans le forum Hardware, firmware and software help

 il y a 5 years
I've had the same experience with PETG (very high adhesion)....

Dans le forum General discussion, announcements and releases

 il y a 5 years
Can't upload two pics in a single post, so here's the second...

Dans le forum Hardware, firmware and software help

 il y a 5 years
Okay, I did a PID calibration at 260, and tried to print the...

Dans le forum Hardware, firmware and software help

 il y a 5 years
No, I have not. I haven't done a PID cal since months ago. I...

Dans le forum Hardware, firmware and software help

 il y a 5 years
Thermal runaway, printer keeps "printing"

Dans le forum Hardware, firmware and software help

 il y a 5 years
You have to login Thanks, that was the trick! I was going ...

Dans le forum General discussion, announcements and releases

 il y a 6 years
Advice for 0.6 nozzle settings for MMU2S multi printing?

Dans le forum General discussion, announcements and releases

 il y a 6 years
Can you provide link to the page, please? For the life of me...

Dans le forum General discussion, announcements and releases

 il y a 6 years
Going to try this, as I just had a 2 day print killed by the...

Dans le forum Others (Archive)

 il y a 7 years
Page 2 / 2
Partager :