Notifications
Clear all
Dragon1291
Dragon1291
Groupe: Enregistré
A(ont) rejoint: 2021/01/24
Trusted Member
3
@phisig No harm no foul. But remember you don't know what yo...

Dans le forum Assembly and first prints troubleshooting

il y a 4 years
@phisig 99.9% sure you're not getting enough squish on your ...

Dans le forum Assembly and first prints troubleshooting

il y a 4 years
Biggest factor is the wait time. A 13-14 week wait for the k...

Dans le forum General discussion, announcements and releases

il y a 4 years
I would suspect that as long as you have adequate cooling an...

Dans le forum General discussion, announcements and releases

il y a 4 years
Looking at the heatbreak drawing:br />The PTFE tube has 6 mm...

Dans le forum General discussion, announcements and releases

il y a 4 years
So we're looking at a +3.03% to +5.25% Variance here with no...

Dans le forum General discussion, announcements and releases

il y a 4 years
Should I pack my bearings once I get my Mk3S+ Kit?

Dans le forum General discussion, announcements and releases

il y a 4 years
Contact Prusa Support via Email or the Popup chatbox in the ...

Dans le forum General discussion, announcements and releases

il y a 4 years
@technogeeky Well I'm glad someone was able to confirm that ...

Dans le forum General discussion, announcements and releases

il y a 4 years
@fuchsr Normally I would agree, but with the lives of my bir...

Dans le forum General discussion, announcements and releases

il y a 4 years
@turro75 @fuchsr Thanks for the info. I might end up going f...

Dans le forum General discussion, announcements and releases

il y a 4 years
Mini Hotend question

Dans le forum General discussion, announcements and releases

il y a 4 years
@dimprov Wish these kits had the option of including electro...

Dans le forum General discussion, announcements and releases

il y a 4 years
RE: Recommendations for a 3D printer with build area of 400x...

Dans le forum General discussion, announcements and releases

il y a 4 years
@dimprov From what I remember and google it's been a "featur...

Dans le forum General discussion, announcements and releases

il y a 4 years
Feel free to share the Gcode files and I'll be happy to look...

Dans le forum PrusaSlicer

il y a 4 years
Honestly at that point might as well get another mk3 and jus...

Dans le forum General discussion, announcements and releases

il y a 4 years
Well Prusa does tout "Heatbed with cold corners compensation...

Dans le forum General discussion, announcements and releases

il y a 4 years
[email protected] How to handle a warranty case Any warranty ...

Dans le forum General discussion, announcements and releases

il y a 4 years
I would just try comparing two gcode files (one that reports...

Dans le forum PrusaSlicer

il y a 4 years
Page 3 / 5
Partager :