Prusa3D Forum

Notifications

Clear all

dj_segfault

Grupa: Zarejestrowany

Dołączył: 2020/10/06

Active Member

	FYI the problem with the temperature has resolved itself by ... In forum Hardware, firmware and software help	3 years temu
	I did do that afterwards because I noticed when it was doing... In forum Hardware, firmware and software help	3 years temu
	Normally print PLA. Tried print PETG now it always goes to 2... In forum Hardware, firmware and software help	3 years temu
	I tried again and it failed at the same spot, the roof over ... In forum How do I print this? (Printing help)	4 years temu
	Benchy breaking off the bed when almost done In forum How do I print this? (Printing help)	4 years temu

Statystyki Forum

565 Fora

64.1 K Tematy

448.8 K Posty

21 Online

70.1 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte