Prusa3D Forum

Notifiche

Cancella tutti

dj_segfault

Gruppo: Registrato

Registrato: 2020/10/06

Active Member

	FYI the problem with the temperature has resolved itself by ... Nel forum Hardware, firmware and software help	3 years fa
	I did do that afterwards because I noticed when it was doing... Nel forum Hardware, firmware and software help	3 years fa
	Normally print PLA. Tried print PETG now it always goes to 2... Nel forum Hardware, firmware and software help	3 years fa
	I tried again and it failed at the same spot, the roof over ... Nel forum How do I print this? (Printing help)	4 years fa
	Benchy breaking off the bed when almost done Nel forum How do I print this? (Printing help)	4 years fa

Statistiche Forum

565 Forum

63.8 K Discussioni

447.3 K Post

21 Online

69.4 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso