Prusa3D Forum

Notifications

Clear all

dj_segfault

Skupina: Registrovaný

Přidal se: 2020/10/06

Active Member

	FYI the problem with the temperature has resolved itself by ... In forum Hardware, firmware and software help	před 3 years
	I did do that afterwards because I noticed when it was doing... In forum Hardware, firmware and software help	před 3 years
	Normally print PLA. Tried print PETG now it always goes to 2... In forum Hardware, firmware and software help	před 3 years
	I tried again and it failed at the same spot, the roof over ... In forum How do I print this? (Printing help)	před 4 years
	Benchy breaking off the bed when almost done In forum How do I print this? (Printing help)	před 4 years

Fórum Statistiky

565 Fóra

63.8 K Témata

447.3 K Příspěvky

22 Online

69.4 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed