Avisos
Vaciar todo
dj_segfault
Grupo: Registrado
Registrado: 2020/10/06
Active Member
1
|
FYI the problem with the temperature has resolved itself by ... En el foro Hardware, firmware and software help |
hace 3 years | |
|
I did do that afterwards because I noticed when it was doing... En el foro Hardware, firmware and software help |
hace 3 years | |
|
Normally print PLA. Tried print PETG now it always goes to 2... En el foro Hardware, firmware and software help |
hace 3 years | |
|
I tried again and it failed at the same spot, the roof over ... En el foro How do I print this? (Printing help) |
hace 4 years | |
|
Benchy breaking off the bed when almost done En el foro How do I print this? (Printing help) |
hace 4 years |