Notifications
Clear all
David Wybourn
David Wybourn
Grupa: Zarejestrowany
Dołączył: 2015/07/04
Eminent Member
2
Z levelling enforced

In forum Hardware, firmware and software help

3 years temu
Slanted prints

In forum Assembly and first prints troubleshooting

5 years temu
Layer shift on Y axis after mmu2 upgrade

In forum Assembly and first prints troubleshooting

5 years temu
Yes, I double checked that. The thermistor hasn't moved.

In forum Others (Archive)

8 years temu
Hotend thermistor not changing

In forum Others (Archive)

8 years temu
Heated bed screw holders

In forum Others (Archive)

8 years temu
I tried out new cables for the LCD and everything is working...

In forum Others (Archive)

8 years temu
Thanks, I've ordered a replacement which should hopefully ar...

In forum Others (Archive)

8 years temu
I think I'm going to try replacing the ribbon cables and the...

In forum Others (Archive)

8 years temu
Ok, so I tried switching cables again on the Rambo and I've ...

In forum Others (Archive)

8 years temu
Thanks for the reply. The problem is that the cables don't ...

In forum Others (Archive)

8 years temu
Testing the LCD

In forum Others (Archive)

8 years temu
Rambo board (not mini)

In forum Prusa i3 kit (Archive)

8 years temu
Thanks for all your help. Unfortunately online support were ...

In forum Prusa i3 kit (Archive)

8 years temu
I've double checked the connections, they're all correct. I ...

In forum Prusa i3 kit (Archive)

8 years temu
I'll double check the connectors but I doubt the fan turning...

In forum Prusa i3 kit (Archive)

8 years temu
The extruder fan comes on when the power is on (this has alw...

In forum Prusa i3 kit (Archive)

8 years temu
Just tested the fuses, they're all working fine. The leds ...

In forum Prusa i3 kit (Archive)

8 years temu
Printer not connecting and screen not working.

In forum Prusa i3 kit (Archive)

8 years temu
Thanks for all your help, I lower the speed slightly and it ...

In forum Prusa i3 kit (Archive)

9 years temu
Strona 1 / 2
Share: