Notifications
Clear all
David Wybourn
David Wybourn
Groupe: Enregistré
A(ont) rejoint: 2015/07/04
Eminent Member
2
Z levelling enforced

Dans le forum Hardware, firmware and software help

il y a 3 years
Slanted prints

Dans le forum Assembly and first prints troubleshooting

il y a 5 years
Layer shift on Y axis after mmu2 upgrade

Dans le forum Assembly and first prints troubleshooting

il y a 5 years
Yes, I double checked that. The thermistor hasn't moved.

Dans le forum Others (Archive)

il y a 8 years
Hotend thermistor not changing

Dans le forum Others (Archive)

il y a 8 years
Heated bed screw holders

Dans le forum Others (Archive)

il y a 8 years
I tried out new cables for the LCD and everything is working...

Dans le forum Others (Archive)

il y a 8 years
Thanks, I've ordered a replacement which should hopefully ar...

Dans le forum Others (Archive)

il y a 8 years
I think I'm going to try replacing the ribbon cables and the...

Dans le forum Others (Archive)

il y a 8 years
Ok, so I tried switching cables again on the Rambo and I've ...

Dans le forum Others (Archive)

il y a 8 years
Thanks for the reply. The problem is that the cables don't ...

Dans le forum Others (Archive)

il y a 8 years
Testing the LCD

Dans le forum Others (Archive)

il y a 8 years
Rambo board (not mini)

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
Thanks for all your help. Unfortunately online support were ...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
I've double checked the connections, they're all correct. I ...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
I'll double check the connectors but I doubt the fan turning...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
The extruder fan comes on when the power is on (this has alw...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
Just tested the fuses, they're all working fine. The leds ...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
Printer not connecting and screen not working.

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
Thanks for all your help, I lower the speed slightly and it ...

Dans le forum Prusa i3 kit (Archive)

il y a 9 years
Page 1 / 2
Partager :