Notifications
Clear all
David Wybourn
David Wybourn
Group: Registered
Joined: 2015/07/04
Eminent Member
2
Z levelling enforced

In forum Hardware, firmware and software help

2 years ago
Slanted prints

In forum Assembly and first prints troubleshooting

5 years ago
Layer shift on Y axis after mmu2 upgrade

In forum Assembly and first prints troubleshooting

5 years ago
Yes, I double checked that. The thermistor hasn't moved.

In forum Others (Archive)

8 years ago
Hotend thermistor not changing

In forum Others (Archive)

8 years ago
Heated bed screw holders

In forum Others (Archive)

8 years ago
I tried out new cables for the LCD and everything is working...

In forum Others (Archive)

8 years ago
Thanks, I've ordered a replacement which should hopefully ar...

In forum Others (Archive)

8 years ago
I think I'm going to try replacing the ribbon cables and the...

In forum Others (Archive)

8 years ago
Ok, so I tried switching cables again on the Rambo and I've ...

In forum Others (Archive)

8 years ago
Thanks for the reply. The problem is that the cables don't ...

In forum Others (Archive)

8 years ago
Testing the LCD

In forum Others (Archive)

8 years ago
Rambo board (not mini)

In forum Prusa i3 kit (Archive)

8 years ago
Thanks for all your help. Unfortunately online support were ...

In forum Prusa i3 kit (Archive)

8 years ago
I've double checked the connections, they're all correct. I ...

In forum Prusa i3 kit (Archive)

8 years ago
I'll double check the connectors but I doubt the fan turning...

In forum Prusa i3 kit (Archive)

8 years ago
The extruder fan comes on when the power is on (this has alw...

In forum Prusa i3 kit (Archive)

8 years ago
Just tested the fuses, they're all working fine. The leds ...

In forum Prusa i3 kit (Archive)

8 years ago
Printer not connecting and screen not working.

In forum Prusa i3 kit (Archive)

8 years ago
Thanks for all your help, I lower the speed slightly and it ...

In forum Prusa i3 kit (Archive)

9 years ago
Page 1 / 2
Share: