Notifiche
Cancella tutti
David Wybourn
David Wybourn
Gruppo: Registrato
Registrato: 2015/07/04
Eminent Member
2
Z levelling enforced

Nel forum Hardware, firmware and software help

3 years fa
Slanted prints

Nel forum Assembly and first prints troubleshooting

5 years fa
Layer shift on Y axis after mmu2 upgrade

Nel forum Assembly and first prints troubleshooting

5 years fa
Yes, I double checked that. The thermistor hasn't moved.

Nel forum Others (Archive)

8 years fa
Hotend thermistor not changing

Nel forum Others (Archive)

8 years fa
Heated bed screw holders

Nel forum Others (Archive)

8 years fa
I tried out new cables for the LCD and everything is working...

Nel forum Others (Archive)

8 years fa
Thanks, I've ordered a replacement which should hopefully ar...

Nel forum Others (Archive)

8 years fa
I think I'm going to try replacing the ribbon cables and the...

Nel forum Others (Archive)

8 years fa
Ok, so I tried switching cables again on the Rambo and I've ...

Nel forum Others (Archive)

8 years fa
Thanks for the reply. The problem is that the cables don't ...

Nel forum Others (Archive)

8 years fa
Testing the LCD

Nel forum Others (Archive)

8 years fa
Rambo board (not mini)

Nel forum Prusa i3 kit (Archive)

8 years fa
Thanks for all your help. Unfortunately online support were ...

Nel forum Prusa i3 kit (Archive)

8 years fa
I've double checked the connections, they're all correct. I ...

Nel forum Prusa i3 kit (Archive)

8 years fa
I'll double check the connectors but I doubt the fan turning...

Nel forum Prusa i3 kit (Archive)

8 years fa
The extruder fan comes on when the power is on (this has alw...

Nel forum Prusa i3 kit (Archive)

8 years fa
Just tested the fuses, they're all working fine. The leds ...

Nel forum Prusa i3 kit (Archive)

8 years fa
Printer not connecting and screen not working.

Nel forum Prusa i3 kit (Archive)

8 years fa
Thanks for all your help, I lower the speed slightly and it ...

Nel forum Prusa i3 kit (Archive)

9 years fa
Pagina 1 / 2
Condividi: