|
Z levelling enforced In forum Hardware, firmware and software help |
3 years ago |
|
Slanted prints In forum Assembly and first prints troubleshooting |
6 years ago |
|
Layer shift on Y axis after mmu2 upgrade In forum Assembly and first prints troubleshooting |
6 years ago |
|
Yes, I double checked that. The thermistor hasn't moved. In forum Others (Archive) |
8 years ago |
|
Hotend thermistor not changing In forum Others (Archive) |
8 years ago |
|
Heated bed screw holders In forum Others (Archive) |
8 years ago |
|
I tried out new cables for the LCD and everything is working... In forum Others (Archive) |
8 years ago |
|
Thanks, I've ordered a replacement which should hopefully ar... In forum Others (Archive) |
8 years ago |
|
I think I'm going to try replacing the ribbon cables and the... In forum Others (Archive) |
8 years ago |
|
Ok, so I tried switching cables again on the Rambo and I've ... In forum Others (Archive) |
8 years ago |
|
Thanks for the reply.
The problem is that the cables don't ... In forum Others (Archive) |
8 years ago |
|
Testing the LCD In forum Others (Archive) |
8 years ago |
|
Rambo board (not mini) In forum Prusa i3 kit (Archive) |
9 years ago |
|
Thanks for all your help. Unfortunately online support were ... In forum Prusa i3 kit (Archive) |
9 years ago |
|
I've double checked the connections, they're all correct. I ... In forum Prusa i3 kit (Archive) |
9 years ago |
|
I'll double check the connectors but I doubt the fan turning... In forum Prusa i3 kit (Archive) |
9 years ago |
|
The extruder fan comes on when the power is on (this has alw... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Just tested the fuses, they're all working fine.
The leds ... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Printer not connecting and screen not working. In forum Prusa i3 kit (Archive) |
9 years ago |
|
Thanks for all your help, I lower the speed slightly and it ... In forum Prusa i3 kit (Archive) |
9 years ago |
