Attività
 
Notifiche
Cancella tutti
david.w8
david.w8
Gruppo: Registrato
Registrato: 2016/11/12
Eminent Member
2
MK2 to MK2.5 (not MK2.5S) upgrade instructions

Nel forum Assembly and first prints troubleshooting

2 years fa
did you use filament cooling (fan) during printing? I faced ...

Nel forum Others (Archive)

7 years fa
ie. The printers do not appear to be in an enclosure but the...

Nel forum Others (Archive)

7 years fa
Some more data to share here... I had a ~6 hour print run t...

Nel forum Improvements (Archive)

7 years fa
I have an actively heated enclosure, although I've found the...

Nel forum Improvements (Archive)

7 years fa
The 12V supply going into the Mini Rambo 1.3a (what came in ...

Nel forum Improvements (Archive)

7 years fa
Bump...

Nel forum Others (Archive)

7 years fa
another point to mention: the genuine psu of the i3 mk2 acts...

Nel forum Improvements (Archive)

7 years fa
Late reply here, but I've found that warming the bed up just...

Nel forum Print tips (Archive)

7 years fa
Could you post here what you replaced them with for posterit...

Nel forum Others (Archive)

7 years fa
Why are vent holes removed on MK2S rambo base??

Nel forum Others (Archive)

7 years fa
Printing a solid raft of PETG under Nylon

Nel forum Print tips (Archive)

7 years fa
You might try one of the high temperature PLAs like Raptor P...

Nel forum Others (Archive)

8 years fa
All the prints worked fine for me even using a non-prusa PLA...

Nel forum Others (Archive)

8 years fa
I had the same issue, turned out to be that the XY frame had...

Nel forum Others (Archive)

8 years fa
I went to 1000 and it got rid of a lot of noise and shaking,...

Nel forum Print tips (Archive)

8 years fa
I've measured power at the wall, and even printing ABS at al...

Nel forum Improvements (Archive)

8 years fa
My problem is that both the reader and LCD are flaky. I've j...

Nel forum Prusa i3 kit (Archive)

8 years fa
but the case is intended to keep the heat inside and heat is...

Nel forum Others (Archive)

8 years fa
I built an enclosure around mine using a sheet of 1/2" rigid...

Nel forum Others (Archive)

8 years fa
Pagina 1 / 2
Condividi: