Prusa3D Forum

Benachrichtigungen

Alles löschen

david.w8

Gruppe: Registriert

Beigetreten: 2016/11/12

Eminent Member

	MK2 to MK2.5 (not MK2.5S) upgrade instructions Im Forum Assembly and first prints troubleshooting	Vor 2 years
	did you use filament cooling (fan) during printing? I faced ... Im Forum Others (Archive)	Vor 7 years
	ie. The printers do not appear to be in an enclosure but the... Im Forum Others (Archive)	Vor 7 years
	Some more data to share here... I had a ~6 hour print run t... Im Forum Improvements (Archive)	Vor 7 years
	I have an actively heated enclosure, although I've found the... Im Forum Improvements (Archive)	Vor 7 years
	The 12V supply going into the Mini Rambo 1.3a (what came in ... Im Forum Improvements (Archive)	Vor 7 years
	Bump... Im Forum Others (Archive)	Vor 7 years
	another point to mention: the genuine psu of the i3 mk2 acts... Im Forum Improvements (Archive)	Vor 7 years
	Late reply here, but I've found that warming the bed up just... Im Forum Print tips (Archive)	Vor 7 years
	Could you post here what you replaced them with for posterit... Im Forum Others (Archive)	Vor 7 years
	Why are vent holes removed on MK2S rambo base?? Im Forum Others (Archive)	Vor 7 years
	Printing a solid raft of PETG under Nylon Im Forum Print tips (Archive)	Vor 7 years
	You might try one of the high temperature PLAs like Raptor P... Im Forum Others (Archive)	Vor 8 years
	All the prints worked fine for me even using a non-prusa PLA... Im Forum Others (Archive)	Vor 8 years
	I had the same issue, turned out to be that the XY frame had... Im Forum Others (Archive)	Vor 8 years
	I went to 1000 and it got rid of a lot of noise and shaking,... Im Forum Print tips (Archive)	Vor 8 years
	I've measured power at the wall, and even printing ABS at al... Im Forum Improvements (Archive)	Vor 8 years
	My problem is that both the reader and LCD are flaky. I've j... Im Forum Prusa i3 kit (Archive)	Vor 8 years
	but the case is intended to keep the heat inside and heat is... Im Forum Others (Archive)	Vor 8 years
	I built an enclosure around mine using a sheet of 1/2" rigid... Im Forum Others (Archive)	Vor 8 years

Seite 1 / 2 Nächstes

Forums-Statistiken

559 Foren

62.8 K Themen

442.2 K Beiträge

20 Online

67.3 K Mitglieder

Letzter Beitrag: PSU issue (I think !) Unser neuestes Mitglied: pinklemonade Neueste Beiträge Ungelesene Beiträge Schlagwörter

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen