Notifications
Clear all
Slic3r Acceleration values for infill to reduce noise
Hello,
What is a good value to try for infill acceleration for the following:
- Not slow down the print too much
- Reduce the noise
Another thread to try 1000 or 750. At what value would the print time start to be noticeably longer?
Thanks in advance for your input,
David
Posted : 13/01/2017 10:05 pm
Re: Slic3r Acceleration values for infill to reduce noise
I went to 1000 and it got rid of a lot of noise and shaking, plus the hoftari vibration dampers. I haven't compared print time at all, but it doesn't seem any slower.
Posted : 20/01/2017 5:11 am