|
MK2 to MK2.5 (not MK2.5S) upgrade instructions En el foro Assembly and first prints troubleshooting |
hace 3 years |
|
did you use filament cooling (fan) during printing? I faced ... En el foro Others (Archive) |
hace 7 years |
|
ie. The printers do not appear to be in an enclosure but the... En el foro Others (Archive) |
hace 7 years |
|
Some more data to share here...
I had a ~6 hour print run t... En el foro Improvements (Archive) |
hace 7 years |
|
I have an actively heated enclosure, although I've found the... En el foro Improvements (Archive) |
hace 7 years |
|
The 12V supply going into the Mini Rambo 1.3a (what came in ... En el foro Improvements (Archive) |
hace 7 years |
|
Bump... En el foro Others (Archive) |
hace 7 years |
|
another point to mention: the genuine psu of the i3 mk2 acts... En el foro Improvements (Archive) |
hace 7 years |
|
Late reply here, but I've found that warming the bed up just... En el foro Print tips (Archive) |
hace 7 years |
|
Could you post here what you replaced them with for posterit... En el foro Others (Archive) |
hace 7 years |
|
Why are vent holes removed on MK2S rambo base?? En el foro Others (Archive) |
hace 7 years |
|
Printing a solid raft of PETG under Nylon En el foro Print tips (Archive) |
hace 8 years |
|
You might try one of the high temperature PLAs like Raptor P... En el foro Others (Archive) |
hace 8 years |
|
All the prints worked fine for me even using a non-prusa PLA... En el foro Others (Archive) |
hace 8 years |
|
I had the same issue, turned out to be that the XY frame had... En el foro Others (Archive) |
hace 8 years |
|
I went to 1000 and it got rid of a lot of noise and shaking,... En el foro Print tips (Archive) |
hace 8 years |
|
I've measured power at the wall, and even printing ABS at al... En el foro Improvements (Archive) |
hace 8 years |
|
My problem is that both the reader and LCD are flaky. I've j... En el foro Prusa i3 kit (Archive) |
hace 8 years |
|
but the case is intended to keep the heat inside and heat is... En el foro Others (Archive) |
hace 8 years |
|
I built an enclosure around mine using a sheet of 1/2" rigid... En el foro Others (Archive) |
hace 8 years |
