Prusa3D Forum

Notifications

Clear all

david.w8

Groupe: Enregistré

A(ont) rejoint: 2016/11/12

Eminent Member

	MK2 to MK2.5 (not MK2.5S) upgrade instructions Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	did you use filament cooling (fan) during printing? I faced ... Dans le forum Others (Archive)	il y a 7 years
	ie. The printers do not appear to be in an enclosure but the... Dans le forum Others (Archive)	il y a 7 years
	Some more data to share here... I had a ~6 hour print run t... Dans le forum Improvements (Archive)	il y a 7 years
	I have an actively heated enclosure, although I've found the... Dans le forum Improvements (Archive)	il y a 7 years
	The 12V supply going into the Mini Rambo 1.3a (what came in ... Dans le forum Improvements (Archive)	il y a 7 years
	Bump... Dans le forum Others (Archive)	il y a 7 years
	another point to mention: the genuine psu of the i3 mk2 acts... Dans le forum Improvements (Archive)	il y a 7 years
	Late reply here, but I've found that warming the bed up just... Dans le forum Print tips (Archive)	il y a 7 years
	Could you post here what you replaced them with for posterit... Dans le forum Others (Archive)	il y a 7 years
	Why are vent holes removed on MK2S rambo base?? Dans le forum Others (Archive)	il y a 7 years
	Printing a solid raft of PETG under Nylon Dans le forum Print tips (Archive)	il y a 7 years
	You might try one of the high temperature PLAs like Raptor P... Dans le forum Others (Archive)	il y a 8 years
	All the prints worked fine for me even using a non-prusa PLA... Dans le forum Others (Archive)	il y a 8 years
	I had the same issue, turned out to be that the XY frame had... Dans le forum Others (Archive)	il y a 8 years
	I went to 1000 and it got rid of a lot of noise and shaking,... Dans le forum Print tips (Archive)	il y a 8 years
	I've measured power at the wall, and even printing ABS at al... Dans le forum Improvements (Archive)	il y a 8 years
	My problem is that both the reader and LCD are flaky. I've j... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	but the case is intended to keep the heat inside and heat is... Dans le forum Others (Archive)	il y a 8 years
	I built an enclosure around mine using a sheet of 1/2" rigid... Dans le forum Others (Archive)	il y a 8 years

Page 1 / 2 Suivant

Statistiques du forum

559 Forums

62.8 K Sujets

442.2 K Messages

19 En-ligne

67.3 K Membres

Le dernier des messages: MK4s Problem Z Naht "zufällig" > Materialüberschuss / Propfen am Ansatz Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé