Notifications
Clear all
cwbullet
cwbullet
Groupe: PrusaLink-beta
A(ont) rejoint: 2018/07/13
Titre: Membre
This is a firmware issue. 3 hrs with support. I had the sa...

Dans le forum Assembly and first prints troubleshooting

il y a 1 year
I have been asked I I had any issues. I have one that is on...

Dans le forum General discussion, announcements and releases

il y a 1 year
No issue. Any other targeted photos?

Dans le forum General discussion, announcements and releases

il y a 1 year
\\ It is upside down, but at the bottom is the electronics b...

Dans le forum General discussion, announcements and releases

il y a 1 year
You can see the arms that support the print bed. They are m...

Dans le forum General discussion, announcements and releases

il y a 1 year
Now, you install the upper section. Again- 8 screws. &...

Dans le forum General discussion, announcements and releases

il y a 1 year
The next step is to assemble the LCD and run the wires. Run...

Dans le forum General discussion, announcements and releases

il y a 1 year
Anyone else want a targeted photo?

Dans le forum General discussion, announcements and releases

il y a 1 year
The bottom of the print bed is very impressive. Each section...

Dans le forum General discussion, announcements and releases

il y a 1 year
My issue when I reveal it is one I would have had with or wi...

Dans le forum General discussion, announcements and releases

il y a 1 year
I have not. I switched my order from a 3.5 to 4 a few weeks...

Dans le forum General discussion, announcements and releases

il y a 1 year
For most, I suspect this will be more like 6-8.

Dans le forum General discussion, announcements and releases

il y a 1 year
It is disappointing, but no reason to get bent out of shape....

Dans le forum General discussion, announcements and releases

il y a 1 year
Uprights installed: First step done with 8 screws. Pretty ...

Dans le forum General discussion, announcements and releases

il y a 1 year
Gathering the parts for the first step: It is to install th...

Dans le forum General discussion, announcements and releases

il y a 1 year
The printer base comes pre-assembled.

Dans le forum General discussion, announcements and releases

il y a 1 year
Z Motor and side panels.  IMG_3230.jpeg

Dans le forum General discussion, announcements and releases

il y a 1 year
I am going to take a picture. I forgot last night, but the ...

Dans le forum General discussion, announcements and releases

il y a 1 year
Print bed porn.....

Dans le forum General discussion, announcements and releases

il y a 1 year
Print sheets - Check.

Dans le forum General discussion, announcements and releases

il y a 1 year
Page 14 / 559
Partager :