PrusaSlicer hard to remove supports
 
Notifiche
Cancella tutti

PrusaSlicer hard to remove supports  

Pagina 7 / 7
  RSS
RD2-3D
(@rd2-3d)
Active Member
RE: PrusaSlicer hard to remove supports

Thanks Joan, I had missed the post adapting the parameters to the new settings. Everything is clearer now.

Thanks anyway

Postato : 28/06/2022 6:00 am
Morpheus31
(@morpheus31)
Active Member
RE: PrusaSlicer hard to remove supports

Following up on this.  Would you please upload a snapshot of all your settings?  Appreciate it.

Posted by: @cwbullet

I am out of town for 10 days.  I will do so when I return.  

 

Postato : 05/07/2022 7:33 pm
IceKillFX57
(@icekillfx57)
New Member
RE: PrusaSlicer hard to remove supports

yes, please make a Screenshot with Prusa 2.4.2

Postato : 18/07/2022 8:40 am
cwbullet
(@cwbullet)
RE: PrusaSlicer hard to remove supports

Here you go.  

--------------------
Chuck H
3D Printer Review Blog

Postato : 18/07/2022 9:10 am
Midi86
(@midi86)
New Member
RE: PrusaSlicer hard to remove supports

Interface pattern spacing should be 0.3mm, not 3mm right?

Posted by: @cwbullet

Here you go.  

 

Postato : 16/08/2022 9:02 am
Neophyl
(@neophyl)
Famed Member
RE: PrusaSlicer hard to remove supports

In my book yes, personally I wouldn't have the interface that widely spaced.  Many support settings come down to personal preference but I also increase the interface layers from 2 to 4.  I find that printing a thicker section of interface makes it easier to remove in one piece as it doesn't break up as much and will sort of peel off easier. 

Postato : 16/08/2022 9:10 am
kevman
(@kevman)
Estimable Member
RE: PrusaSlicer hard to remove supports

these settings are working out pretty good for me on snug supports.

 

Postato : 21/08/2022 2:29 am
Daniel Petcu hanno apprezzato
Daniel Petcu
(@daniel-petcu)
New Member
RE:

Thank you very much @bobstro .It worked very well for Colorfabb TPU Varioshore. 

Any suggestion on how can I improve the surface quality after removing supports?

Thank you in advance!

Questo post è stato modificato 1 week fa 3 tempo da Daniel Petcu
Postato : 25/09/2022 1:18 pm
Pagina 7 / 7
Condividi: