Please some advice on first layer of this two color badge
With the advice of Joan Tabb (as written in https://forum.prusa3d.com/forum/prusaslicer/manual-multicolor/ ) I managed two make a first successful test of a two color-badge. Wonder how I could improve the first layer even more. Please have a look at this picture, and maybe some good advice.
Nozzle 0.4mm
layer height 0.2 mm
first layer height 0.25 mm
first layer width: 0.4mm
220 / 70 Celcius first layer
215 / 60 for other layers.
Thank you all. regards, Eef
We will do what we have always done. We will find hope in the impossible.
RE: Please some advice on first layer of this two color badge
looks like your Live Z value, is too large a negative number
not a lot... but small adjustment would help
Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
RE:
Results after a couple of weeks experimenting, polishing and very helpfull: calibrating with PETG. 
Maybe it can be better then this But for now happy with the results.
Thank you for the advice.
We will do what we have always done. We will find hope in the impossible.