Where is the input shaper profile for prusa XL multi-tool
 
Notifiche
Cancella tutti

Where is the input shaper profile for prusa XL multi-tool  

  RSS
MK Ultra
(@mk-ultra)
Active Member
Where is the input shaper profile for prusa XL multi-tool

I heard the prusa XL has input shaper profiles with print speeds about 170 m/s. Checking the latest prusa slicer, the fastest speed is currently at 90m/s and theres no input shaper profile for the XL on the printer configurations page. The MK4 has the input shaper profile on there with proper faster speeds.  Was it the input shaper taken out of the slicer?

Postato : 21/06/2024 5:17 pm
mvikman
(@mvikman)
Trusted Member
RE: Where is the input shaper profile for prusa XL multi-tool

I'm on PS 2.7.4 and XL IS profiles are listed in the config wizard, I have them installed for my 2-tool XL.

Postato : 21/06/2024 6:24 pm
MK Ultra
(@mk-ultra)
Active Member
Topic starter answered:
RE: Where is the input shaper profile for prusa XL multi-tool

Ahh I see I had to install the updated configs... Thank you!!

Postato : 21/06/2024 6:50 pm
Condividi: