Layershifts printing tall slightly sloped parts
I'm attempting to print a scale model of a rocket. I keep getting layer shifts where the outer edge is printed slightly wider than it should be. The layer shift is not biased to one direction. It's a circular model and the entire layer is wider than it should be. This continues for about 5 layers and then it is back to the correct position.
The layer shifts occur in the same spot for the part, different heights for different parts.
I lubed and cleaned all axis but didn't help.
RE: Layershifts printing tall slightly sloped parts
Hello and welcome,
maybe you observe something similiar like the-benchy-hull-line.
Are changes visible in the slicer at those layers when you move the slider right of the sliced model down to those?
RE: Layershifts printing tall slightly sloped parts
With the top section (top/first photo) there are two shifts. First is a switch from gap fill to perimeter, then second is the opposite.
RE: Layershifts printing tall slightly sloped parts
This thread might also apply to your problem:
RE:
This appears to be the culprit. I adjusted perimeter width, perimeter speed, and enabled thin wall detection. It didn't eliminate it entirely but close enough.
Thanks a lot!
This thread might also apply to your problem: