Avisos
Vaciar todo
ASA wavy first layer and on covers
Hi
The first time I tried Prusament ASA Jet Black there were waves on the first layer. The filament also became wavy and inaccurate in the edge areas of the covers.
The first layer was very sticky. The powder-coated sheet then had very subtle bubbles in the surface. I used the ASA basic settings of the Prusa Slicer
Thanks for advice!
Respondido : 27/05/2020 10:46 am
RE: ASA wavy first layer and on covers
Waves on the first layer means the nozzle is slightly too close to the sheet usually.
Respondido : 27/05/2020 11:14 am