Notifications
Clear all
No filament extruding during print.
I have an ongoing issue where my printer will extrude filament (PLA) manually and when performing first layer calibration.
However, when I go to print anything, little to no filament comes out. I just don't seem to be able to rectify this issue.
Any help really appreciated.
Publié : 22/05/2022 5:13 pm
RE: No filament extruding during print.
I'm dealing with this exact same problem. I can do a first layer Z thickness print and it looks good. But if try to do a legitimate print, the printer slowly decreases the amount extruded until it's not extruding at all. Last night I did some cold pulls to see if that does it. If it didn't, I will be removing the nozzle and heating it with a torch to see if I can remove whatever obstruction is in there.
Publié : 24/05/2022 4:43 pm
Try drying your filament first.
Chjeeroio,
Publié : 25/05/2022 1:04 am