Adding a 3rd Thermistor to a Prusa MK3S+
Hey everyone!
I was hoping someone had any experience with adding a new thermistor to the empty slot in the Einsy board, and whether the information from it could be displayed on octoprint/ the printer display itself.
I have made an enclosure for the printer and would like to place a thermistor towards the top of the printer frame for better accuracy of the internal temperature.
I ve already looked through the forum and online but have not managed to find any info on this except for a post mentioning that an ambient temperature sensor already exists, however when comparing it to an external sensor I have found that it does not reflect the temperature of the majority of the enclosure and would prefer this method if possible.
Thanks in advance!
RE: Adding a 3rd Thermistor to a Prusa MK3S+
You definitely would have to write your own firmware.
--------------------
Chuck H
3D Printer Review Blog
RE: Adding a 3rd Thermistor to a Prusa MK3S+
Noted with thanks