Benachrichtigungen
Alles löschen

Adding a 3rd Thermistor to a Prusa MK3S+  

  RSS
PrusaUser
(@prusauser)
New Member
Adding a 3rd Thermistor to a Prusa MK3S+

Hey everyone! 

I was hoping someone had any experience with adding a new thermistor to the empty slot in the Einsy board, and whether the information from it could be displayed on octoprint/ the printer display itself. 

I have made an enclosure for the printer and would like to place a thermistor towards the top of the printer frame for better accuracy of the internal temperature. 

I ve already looked through the forum and online but have not managed to find any info on this except for a post mentioning that an ambient temperature sensor already exists, however when comparing it to an external sensor I have found that it does not reflect the temperature of the majority of the enclosure and would prefer this method if possible. 

Thanks in advance!

Dieses Thema wurde geändert Vor 2 years von PrusaUser
Veröffentlicht : 17/06/2022 8:07 pm
cwbullet
(@cwbullet)
Mitglied
RE: Adding a 3rd Thermistor to a Prusa MK3S+

You definitely would have to write your own firmware.  

--------------------
Chuck H
3D Printer Review Blog

Veröffentlicht : 18/06/2022 1:42 am
PrusaUser
(@prusauser)
New Member
Themenstarter answered:
RE: Adding a 3rd Thermistor to a Prusa MK3S+

Noted with thanks

Veröffentlicht : 18/06/2022 8:14 pm
Teilen: