Avisos
Vaciar todo
Still struggling - any ideas?
Hi All,
I have been through the live setup suggested here - I have also recently done the bed leveling hack to get a near perfectly flat bed. I am still getting the below - any ideas?
Thanks
Chris
Respondido : 30/04/2023 10:05 am
RE: Still struggling - any ideas?
I printed the test cube to check my extrusion multiplier and found that it was out. It may be something you need to adjust. I have also been struggling with Z calibration and found an issue today.
Respondido : 01/05/2023 3:21 am