Notifications
Clear all

Still struggling - any ideas?  

  RSS
Chris Purves
(@chris-purves)
Active Member
Still struggling - any ideas?

Hi All,

I have been through the live setup suggested here - I have also recently done the bed leveling hack to get a near perfectly flat bed. I am still getting the below - any ideas?

 

Thanks

Chris

Posted : 30/04/2023 10:05 am
Robin_13
(@robin_13)
Reputable Member
RE: Still struggling - any ideas?

I printed the test cube to check my extrusion multiplier and found that it was out. It may be something you need to adjust.  I have also been struggling with Z calibration and found an issue today.

Extrusion multiplier calibration

Posted : 01/05/2023 3:21 am
Share: