Notifications
Clear all
Filament oozing after print even in Z-Layer Calibration
Hi!
I recently replaced my broken EINSY-board in my MK3S printer and ran the initial setup.
When the Z-Layer calibration print is finished Filament still oozes out of the nozzle. I know I can adjust the extrusion multiplier in Slicer, but the Z-calibration is not even a file I load onto the printer, but in the firmware.
I already checked the bondgear alignment and loosened the bondgear screw so it only just extrudes filament.
Is there anything else I can check or adjust to fix this issue?
Posted : 21/04/2023 4:59 pm
Dry the filament.
Cheerio,
Posted : 21/04/2023 5:33 pm