Replacing nozzle.
Hi all,
I removed my nozzle to clean it but it was damaged. So I ordered a new nozzle. Do I heat up and then place the nozzle or just place the nozzle and then heat for the final few twists what is the best way to go?
Best Answer by Hello:
Heat then in
RE: Replacing nozzle.
Heat then in
Please help me out by downloading a model it's free and easy but really helps me out https://www.printables.com/@Hello_474427/models
Pay particular attention to the diagrams at the bottom of this page:
https://help.prusa3d.com/en/article/changing-or-replacing-the-nozzle-mk2-5s-mk3s-mk3s_2069
Cheerio,
RE: Replacing nozzle.
Also, make sure to do a z-height adjustment. Just to be safe.
Aaron
RE: Replacing nozzle.
I really, really wish there where a knowledge base or something to look up things like that…
If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!