Notifications
Clear all
Odd Behavior During XYZ calibration
Greetings all,
We had a blob that took out the thermister and hot end. So after we replaced the parts we did a recalibrate and we are getting this strange behavior at point 3 Jump to 2:00 to see behavior. It seems like the bed is too high in that corner but i can't seem to get it into flat. Any help would be greatly appreciated.
This topic was modified 5 years ago by ifoundgoldbug
Posted : 24/03/2020 2:50 pm
Topic starter
answered:
RE: Odd Behavior During XYZ calibration
Root cause was found to be loose 1 loose and 1 missing set screw on the X axis gt2-16 pulley. Whomever is reading this I hope that it helps.
Posted : 30/03/2020 5:08 pm