RE: What are printing paraleters for firmware first layer calibration?
@jsw is right, nuances and tone often get lost in translation, things not mentioned to be sound rude or harsh. Just try to be nice and do not think others are not, after all answering to a post can be considered a curtesy already, can it not?
Generally pictures are very helpful, as are project files both do not need translation 🙂
If at first you don't succeed, skydiving is not for you.
RE: What are printing paraleters for firmware first layer calibration?
hli, sorry for late response. Things happened.
I appreciate a lot your advises. Thanks.
I did not find solution but managed to get proper print by intentionally lowering Z layer to the limits. First layer was squished a lot, but at least it managed to stay sticked to the plate until print ended.
As print was about 12hours long and spend half of the spool, I was not very reluctant to do lots of test prints. I guess, this would be solution if some large prints occurs in the future. I would simply squish the first layer to the limit and hope for the best.