Activity
 
Notifications
Clear all
Pedja
Pedja
Group: Registered
Joined: 2020/05/04
Trusted Member
3
Is it possible to print this on MK3s using Prusa Slicer 2.5....

In forum PrusaSlicer

11 months ago
Arc Overhangs, this may be a big step

In forum PrusaSlicer

1 year ago
Thanks, this worked fine. It has some user interface glitche...

In forum PrusaSlicer

1 year ago
Setting up variable layer height in more specific way?

In forum PrusaSlicer

1 year ago
For some reason it is lost. But it does not matter. I see th...

In forum PrusaSlicer

1 year ago
hli, sorry for late response. Things happened.I appreciate a...

In forum How do I print this? (Printing help)

1 year ago
Issue: PrusaSlicer creates overhangs with infill

In forum PrusaSlicer

1 year ago
I guess you are right. I did not understand how it works. I ...

In forum PrusaSlicer

1 year ago
I am not dumb. Of course I cleaned the bed. I guess, after t...

In forum How do I print this? (Printing help)

1 year ago
This is what I ended up doing. I am using test print model i...

In forum How do I print this? (Printing help)

1 year ago
Yes. Clean the build sheet. Cheerio, Well, I must admit y...

In forum How do I print this? (Printing help)

1 year ago
Cannot block supports

In forum PrusaSlicer

1 year ago
Have you actually read what I posted? Your suggestions seem ...

In forum How do I print this? (Printing help)

1 year ago
This is newly open filament. However this issue happens with...

In forum How do I print this? (Printing help)

1 year ago
RE: What are printing paraleters for firmware first layer ca...

In forum How do I print this? (Printing help)

1 year ago
I have no issue with first layer calibration. It works very ...

In forum How do I print this? (Printing help)

1 year ago
What are printing paraleters for firmware first layer calibr...

In forum How do I print this? (Printing help)

1 year ago
It looked quite fine so I was not suspecting. Recreated it j...

In forum PrusaSlicer

2 years ago
It seems recreating STL fixed an issue.

In forum PrusaSlicer

2 years ago
That is exactly what we could avoid if printer is capable to...

In forum General discussion, announcements and releases

2 years ago
Page 1 / 4
Share: